|
Post by superdave008 on Sept 19, 2010 23:46:06 GMT -5
Does anyone have a side glass for a GT-2 ? also looking for a roll bar that will fit a twoie.
Looking , thanks, Dave
Phone 303-829-7660 E-mail superdave008@gmail.com
|
|
|
Post by toy4everyseason on Sept 20, 2010 12:10:05 GMT -5
I have the "roll bar" piece that goes under the roof section but the glass I have is no good. I'll send you an email.
|
|
dean
Junior Member
Posts: 77
|
Post by dean on Sept 20, 2010 17:17:34 GMT -5
I think I have 1 side glass will check and see what side
Dean
|
|
dean
Junior Member
Posts: 77
|
Post by dean on Oct 8, 2010 22:26:22 GMT -5
I do have the drivers side glass
Dean
|
|
dand
New Member
Posts: 20
|
Post by dand on Oct 26, 2010 17:17:27 GMT -5
Folks, I am nearly complete with body work on GT2 getting ready for primer but desire to correct a rear valance panel cutout on passenger side to accept a standard VW muffler install when car was originally built. I have removed the muffler and plan to install a glass pack 3-1/2" diameter tube type muffler that will fit with the standard exhaust flange arrangement. Anyone have that piece so I don't have to glass in that passenger side lower valance? I need about lower 6" passenger side only. Please advise. Thanks, Dan PS: I did body work on the body to flush fit the gullwings into the body and roof in effort to correct the "butt sag" alignment issue. Looks great - used short strand body filler and am very pleased.
|
|